Epson Stylus Pro GS6000 - Page 94

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 94
Confidential
4.4.3.10 FRONT CLEAR COVER
1. Remove the eight screws.
A) Silver, Phillips, Truss machine screw M4x6: eight pieces
2. Slide the FRONT CLEAR COVER to the rear and remove it.
Figure 4-31. Removing the FRONT CLEAR COVER
4.4.3.11 PAPER GUIDE COVER
1. Remove the MAINTENANCE COVER ASSY. (p91)
2. Remove the MAINTE COVER, B. (p92)
3. Remove the five screws and remove the PAPER GUIDE COVER.
A) Silver, Phillips, Pan with S.W & P.W M4x8: three pieces
B) Silver, Phillips, Bind P-tite M4x10: two pieces
Figure 4-32. Removing the PAPER GUIDE COVER
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p184) and perform
specified adjustments after replacing or removing this part.
<Adjustment item>
1. Sensor Test
FRONT CLEAR COVER
A
C H E C K
P O I N T
Basically you can remove this part on the left and the one on the
right in the same way. Therefore this section describes the way to
remove the one on the right only.
PAPER GUIDE COVER
B
A
As seen from the front bottom