Epson Stylus Pro GS6000 - Page 98

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 98
Confidential
6. Remove the five screws on top.
A) Silver, Phillips, Bind machine screw M3x6: five pieces
7. Pull and open the After Heater Cover slightly.
Figure 4-38. Removing the Screws of After Heater Cover (top)
8. Disconnect the four relay connectors. See Figure 4-39.
9. Lift the cover up to disengage the rib and remove it.
Figure 4-39. Removing the After Heater Cover
After Heater Cover
A
C A U T I O N
In the next step to remove the cover, do not pull open the cover
toward you. Otherwise you will damage the rib shown in the figure.
1
2
As seen from the top
3
4
As seen from the top
Rib