Epson Stylus Pro GS6000 - Page 97

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 97
Confidential
4.4.3.14 SPINDLE GUIDE COVER
This part is not specified as an ASP.
1. Remove the REAR PAPER GUIDE. (p96)
2. Remove the eight screws and remove the SPINDLE GUIDE COVER.
A) Silver, Phillips, Pan with S.W & P.W M4x8: eight pieces
Figure 4-36. Removing the SPINDLE GUIDE COVER
4.4.3.15 After Heater Cover
This part is not specified as an ASP.
1. Remove the MAINTENANCE COVER ASSY (both). (p91)
2. Remove the MAINTE COVER, B (both). (p92)
3. Remove the PAPER GUIDE COVER (both). (p94)
4. Open the FRONT CLEAR COVER.
5. Remove the five screws at the bottom.
A) Silver, Phillips, Pan with S.W & P.W M4x8: five pieces
Figure 4-37. Removing the Screws of After Heater Cover (bottom)
C A U T I O N
In the next step, the cover will drop immediately after removing the
last screw. Therefore, make sure to hold the cover when removing
the last few screws.
SPINDLE GUIDE COVER
A
As seen from the rear
B
A
As seen from the front bottom
After Heater Cover