Epson Stylus Pro GS6000 - Page 96

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 96
Confidential
4.4.3.13 REAR PAPER GUIDE
This part is not specified as an ASP.
1. Remove the four screws.
A) Silver, Phillips, Pan with S.W & P.W M4x8: four pieces
2. Slide the REAR PAPER GUIDE toward you a little.
Figure 4-34. Removing the screws of REAR PAPER GUIDE
3. Open it and disconnect the four connectors, then remove the guide.
Figure 4-35. Removing the REAR PAPER GUIDE
C A U T I O N
In the next step, do not touch or loosen the screws securing the
rollers inside of the printer fixed with thread locker (marked with a
red circle). Otherwise, the printer may not print normally. The
screws keep the factory-adjusted Parallelism.
REAR PAPER GUIDE
A
As seen from the rear
As seen from the rear
Do not touch these
REAR PAPER GUIDE
1
2
3
4
As seen
from the rear
Connector