Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEET
NEXT
F
35 34
TM-T90
Specification
(STANDARD)
Command Name
GS ^
Execute macro
GS a
Enable/disable Automatic Status Back (ASB)
GS b
Turn smoothing mode on/off
GS f
Select font for HRI characters
GS g 0
Initialize maintenance counter
GS g 2
Transmit maintenance counter
GS h
Set bar code height
GS k
Print bar code
GS r
Transmit status
GS w
Set bar code width
Kanji command list
(when the Japanese, Simplified Chinese, Traditional Chinese, or Korean model is used)
Command Name
FS !
Set print mode(s) for Kanji characters
FS &
Select Kanji character mode
FS ( A
(*)
Select Kanji character style(s)
FS –
Turn underline mode on/off for Kanji characters
FS .
Cancel Kanji character mode
FS 2
Define user-defined Kanji characters
FS C
Select Kanji character code system
FS S
Set left- and right-side Kanji character spacing
FS W
Turn quadruple-size mode on/off for Kanji characters
(*):
FS ( A
is effective only in Japanese model.
The commands listed below in the first column are defined as “obsolete commands” in the ESC/POS
®
command system. This printer supports both upward-compatible commands and obsolete
commands. However, the upward-compatible commands are recommended for use.
Obsolete command Upward-compatible command
FS p
Print NV bit image
GS ( L
<Function 69>
FS q
Define NV bit image
GS ( L
<Function 67>
GS v 0
Print raster bit image
GS ( L
<Function 112 + 50>
NOTE: “Obsolete commands” are commands that are supported by legacy models; however it is
recommended to replace them with upward-compatible commands, because they will not be
supported in the future products.
To Next Page
Loading...
