5-23
Sub-assembly I
Assembly
Step
Assembly ProcedurePart Name
23
24
(25)
★
Ribbon frame assembly B
Sub-assembly H
Shaft-Carriage guide B
RE (2.3) x 1
(Microswitch lead wires)
• While pushing the Lever-Ribbon fame lightly in the ➡ direction, align
the U-grooves of the Frame-Ribbon with the grooves on the Shaft-
Carriage guide A.
• Pass the Shaft-Carriage guide B through the Frame-Ribbon, Print
frame sub-assembly, and carriage assembly pawls R. Then fasten
the shaft with the E-ring.
• Solder the microswitch lead wires to the points on the Relay circuit
board assembly.
<Checkpoint>
• Make sure to route the microswitch lead wires as shown in the figure.
CONFIDENTIAL
To Next Page
Loading...
