5-22
Sub-assembly I
Assembly
Step
Assembly ProcedurePart Name
19
20
(21)
22
★
Insulation sheet
Earth plate-Print head
(FFC-Print head)
Print head unit
CPP-tite (M3 x 10) x 1
• Paste the Insulation sheet to the Earth plate-Print head.
• Place the Earth plate-Print head on the Carriage assembly. (The
plate is not fastened here. It is fastened in
Main Assembly 16
.)
• Attach the FFC-Print head to the print head unit connector.
• Attach the Print head unit to the Carriage assembly and tighten the
screw provisionally. (Final tightening is done in the platen gap
adjustment performed in
Main Assembly 16
.
<Checkpoint>
• Make sure that the left and right sides of the Insulation sheet are not
protruded from the Earth plate-Print head.
CONFIDENTIAL
To Next Page
Loading...
