Appendix A Assembly Instructions
A-30 ER1 User Guide
3. Double click on the behaviors subdirectory to open it. This will display a list of the
.rbt files in this directory.
4. Select the
ER1box.rbt file and click on the Open button to load it.
5. The
ER1box.rbt behavior set will load.
6. Click on the green Run It button at the top right of the RCC program screen.
7. Pick up the box that the robot was packed in, and show it to the robot (the front side of
the box with the multicolored ER1s should be facing the robot's camera).
8. The robot should tell you that it sees the box, and that it will move towards the box if
you move the box farther away from it. Try moving the box various distances from the
robot.
9. When you're done with the robot behavior, click Stop.
Important Note: If you didn’t get a chance while you were installing the software, take a
minute to look at the Release Notes in the
docs subdirectory of the ER1 program
directory. You will find important information that is not included in this manual.
Uninstalling
If you use the Control Panel’s Add/Remove Software Programs utility, make sure that you
also delete the entire installation folder, which will contain user data files, log files, and
captured images.
To Next Page
Loading...