Evolution Robotics ER1 - Have ER1 Play Your Favorite 20 Songs; Tell Your Dog to Be Quiet! if It Barks too

ER1 User Guide C-5
Easy
3. Click on the Behavior Settings button in the upper right of the screen.
4. Click on the Run tab and checkmark the box labeled Let behavior run more than
once.
5. Click on the Ok button.
6. Click ER1’s Run it button.
7. Each time you say “favorite song” clearly so ER1 can hear, ER1 should play your
favorite song.
8. Save the behavior and then click on Open to get a new, blank behavior set.
Have ER1 play your favorite 20 songs
1. Under If, on the Behavior 1 tab, checkmark Sound and type “jukebox” in the Listen
for field.
2. Under Then, click on Play a Sound and browse your hard drive for the first song you
want to hear. Click on it and press the Ok button.
3. Click on the Behavior 2 tab, checkmark Sequence, and select Behavior 1. (This
means Behavior 2 will run immediately after Behavior 1.)
4. Under Then, click on Play a Sound and browse your hard drive for the second song
you want to hear. Click on it and press the Ok button.
5. Click on the Behavior 3 tab, checkmark Sequence, select Behavior 2 and select the
third song you want to hear just as you did in the previous step.
6. Continue using Behavior tabs, one per song, until you are done. Use the Sequence
option to link each behavior to the previous behavior.
7. When you have finished linking all 20 of your favorite songs together, click ER1’s
Run it button.
8. Say “jukebox” clearly so ER1 can hear.
9. ER1 should play all your favorite songs in order.
10. Save the behavior and then click on Open to get a new, blank behavior set.
Tell your dog to “Be quiet!” if it barks too loud
1. Under If on a blank behavior tab, checkmark Sound and select a volume level from
the Level checkboxes (volume increases from left to right).
2. Under Then, click on Play a Sound and type, “Be quiet!” in the Phrase to Speak
field.
3. Click on the Behavior Settings button in the upper right of the screen.
4. Click on the Run tab and checkmark the box labeled Let behavior run more than
once.
5. Click on the Ok button.
6. Click ER1’s Run it button.