ER1 User Guide A-7
Assembling Your “Assembled” ER1
Assembling Your “Assembled” ER1
This section describes the procedure to assemble your pre-assembled robot. Because of
the configuration of the robot, it must be shipped in several pieces to avoid damage to the
components. Remember to check your parts against your packing list to make sure you
have received all of the parts you will need to build your ER1. Note that the list of parts
for the assembled robot is slightly different than that of the unassembled robot.
STOP!!! Have you read the Getting to Know the Parts section? This section gives you the
necessary information on the robot parts. Remember to refer to this section if you need
further clarification on the assembly instructions.
Step 1.
You need:
• All of the robot parts from the
box.
Instructions:
• You should have everything
shown here.
To Next Page
Loading...