Chapter 8 Settings
8-8 ER1 User Guide
Request timed out.
Request timed out.
Ping statistics for 192.168.12.1:
Packets: Sent = 4, Received = 0, Lost = 4 (100% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms
Here's an example of a successful ping:
C:\>ping 10.1.3.57
Pinging 10.1.3.57 with 32 bytes of data:
Reply from 10.1.3.57: bytes=32 time=31ms TTL=64
Reply from 10.1.3.57: bytes=32 time<10ms TTL=64
Reply from 10.1.3.57: bytes=32 time<10ms TTL=64
Reply from 10.1.3.57: bytes=32 time<10ms TTL=64
Ping statistics for 10.1.3.57:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 31ms, Average = 7ms
C:\>
9. Click on the Settings button and then the Remote Control tab. Check the box for
Allow Remote Control.
10. Install the RCC software on your remote computer, and start the application.
11. Click on the Settings button again. In the Remote Control tab, check the box for
Control robot at this IP address. Enter the robot's laptop IP address in the space
provided.
12. Leave the default as Port 9000.
Options are:
• Disable Remote Control - If this checkbox is selected, remote control of your
robot is disallowed.
• Allow remote control of this instance - If you want to remotely control your
robot, click this checkbox on the robot's laptop. You will also need to go to the
remote computer and click Control robot at this IP address. (If you close the
ER1 application, then restart it, you will have to re-select this option.)
• Control robot at this IP address - If this option is selected, the IP address,
port and password for the robot's laptop must be supplied.
• Allow API Control of this instance - If this option is selected, the ER1 can be
controlled using the API instead of through the RCC interface. If this option is
selected, a port must be specified. You may also specify a password if desired.
See the Application Programmer’s Interface section for details. Note that if this
option is specified, you cannot control the robot using the RCC software until
you discontinue your API session.
• Reset the network connection now - If your computer and your robot are
using wireless communication, the present limitations of the technology mean
To Next Page
Loading...