·190·
Programming manual
CNC 8055
CNC 8055i
9.
CANNED CYCLES
·M· & ·EN· MODELS
SOFT: V02.2X
G88. Circular pocket canned cycle
[ D5.5 ] Reference plane
Defines the distance between the reference plane and the surface of the part where the pocket is
to be made.
During the first deepening operation this amount will be added to incremental depth "B". If not
programmed, a value of 0 is assumed.
[ H5.5 ] Feedrate for the finishing pass
Defines the working feedrate during the finishing pass.
If not programmed or programmed with a 0 value, it assumes the value of the machining feedrate.
[ L5.5 ] Finishing stock
Defines the value of the finishing pass, along the main plane.
If not programmed or programmed with a 0 value, it does not run the finishing pass.
To Next Page
Loading...
