Fagor 8055 M - Page 385

Programming manual
CNC 8055
CNC 8055i
HIGH-LEVEL LANGUAGE PROGRAMMING
13.
·M· & ·EN· MODELS
SOFT: V02.2X
·385·
Variables
ANAIn
It returns the status of the indicated analog input (n). The value given in Volts and in ±1.4 format.
• At the –Axes– module, it is possible to select one of the 8 analog inputs (1··8) available. The
values returned will be within the ±5 V range.
• At the –Vpp Axes– module, it is possible to select one of the 4 analog inputs (1··4) available.
The returned values will be either within the ±5 V or ±10 V range depending on how the analog
inputs have been set.
If this variable is accessed, block preparation is interrupted and the CNC waits for this command
to be executed to resume block preparation.
AXICOM
It returns in the 3 least significant bits the axis pairs switched with function G28.
The axes are coded in 4 bits and indicate the axis number (1 to 7) according to their programming
order.
If the CNC controls the X, Y, Z, B, C axes and G28BC has been programmed, the AXICOM variable
will show:
TANGAN
Variable associated with the tangential control function, G45. It indicates the programmed angular
position.
TPIOUT(X-C)
Output of the PI of the tandem master axis in rpm.
TIMEG
It shows the timing status of the timer programmed with G4 K in the CNC channel. This variable,
returns the time remaining to end the timing block in hundredths of a second.
TIPPRB
It indicates the PROBE cycle being executed at the CNC.
If PROBE1 is running, the TPPRB variable takes the value of 1, if PROBE2 is running, it takes the
value of 2, etc. if PROBE12 is running, it takes the value of 12.
TIPDIG
It indicates the DIGIT cycle being executed at the CNC.
PANEDI
WINDRAW55 application. Number of the screen created by the user or the manufacturer and is
being consulted.
DATEDI
WINDRAW55 application. Number of the element (item) being consulted.
RIP
Linear theoretical feedrate resulting from the next loop (in mm/min).
The calculation of the resulting feedrate ignores the rotary axes, slave axes (gantry, coupled and
synchronized) as well as DRO axes.
Pair 3 Pair 2 Pair 1
Axis 2 Axis 1 Axis 2 Axis 1 Axis 2 Axis 1 LSB
Pair 3 Pair 2 Pair 1
CB
0000 0000 0000 0000 0101 0100 LSB