·384·
Programming manual
CNC 8055
CNC 8055i
13.
HIGH-LEVEL LANGUAGE PROGRAMMING
·M· & ·EN· MODELS
SOFT: V02.2X
Variables
ROTPS
Returns the ordinate value of the rotation center with respect to the Cartesian coordinate origin. It
is given in the active units:
If G70, in inches (within ±3937.00787).
If G71, in millimeters (within ±99999.9999).
PRBST
Returns probe status.
0 = the probe is not touching the part.
1 = the probe is touching the part.
If this variable is accessed, block preparation is interrupted and the CNC waits for this command
to be executed to resume block preparation.
CLOCK
Returns the time in seconds indicated by the system clock. Possible values 0..4294967295.
If this variable is accessed, block preparation is interrupted and the CNC waits for this command
to be executed to resume block preparation.
TIME
Returns the time in hours-minutes-seconds format.
If this variable is accessed, block preparation is interrupted and the CNC waits for this command
to be executed to resume block preparation.
DATE
Returns the date in year-month-day format.
If this variable is accessed, block preparation is interrupted and the CNC waits for this command
to be executed to resume block preparation.
CYTIME
It returns the amount of time (in hundredths of a second) elapsed executing the part. It ignores the
time the execution has been interrupted. Possible values 0..4294967295.
If this variable is accessed, block preparation is interrupted and the CNC waits for this command
to be executed to resume block preparation.
FIRST
Indicates whether it is the first time that a program has been run or not. It returns a value of 1 if it
is the first time and 0 if not.
A first-time execution is considered as being one which is done:
• After turning on the CNC.
• After pressing [SHIFT]+[RESET].
• Every time a new program is selected.
(P150=TIME)
Loads P150 with hh-mm-ss. For example if the time is: 34sec. P150 = 182234.
(P151=DATE)
It assigns to P151 the year-month-day. For example if the date is April 25th 1992, P151
= 920425.
To Next Page
Loading...
