Programming manual
CNC 8055
CNC 8055i
HIGH-LEVEL LANGUAGE PROGRAMMING
13.
·M· & ·EN· MODELS
SOFT: V02.2X
·383·
Variables
PLANE
Returns data on the abscissa axis (bits 4 to 7) and the ordinate axis (bits 0 to 3) of the active plane
in 32 bits and in binary.
The axes are coded in 4 bits and indicate the axis number according to the programming order.
Example: If the CNC controls the X,Y,Z,U,B,C axes and the ZX plane (G18) is selected.
(P122 = GS17) assigns value $31 to parameter P122.
Abscissa axis = 3 (0011) => Z axis
Ordinate axis = 1 (0001) => X axis
LONGAX
It returns the number according to the programming order corresponding to the longitudinal axis.
This will be the one selected with the G15 function and by default the axis perpendicular to the active
plane, if this is XY, ZX or YZ.
Example:
If the CNC controls the X, Y, Z, U, B, C axes and the U axis is selected.
(P122 = LONGAX) assigns the value 4 to parameter P122.
MIRROR
Returns in the least significant bits of the 32-bit group, the status of the mirror image of each axis,
1 in the case of being active and 0 if not.
The axis name corresponds to the number according to the programming order for them.
Example: If the CNC controls axes X, Y, Z, U, B, C, axis 1=X, axis2=Y, axis3=Z, axis4=U, axis5=B,
axis6=C.
SCALE
It returns the general scaling factor being applied.
SCALE(X-C)
Returns the specific scaling factor of the indicated axis (X-C).
ORGROT
It returns the rotation angle of the coordinate system currently selected with G73. Its value is given
in degrees (within ±99999.9999).
ROTPF
Returns the abscissa value of the rotation center with respect to the Cartesian coordinate origin.
It is given in the active units:
If G70, in inches (within ±3937.00787).
If G71, in millimeters (within ±99999.9999).
0000 0000 0000 0000 0000 0000 0011 0001 LSB
... ... ... ... ... ... 7654 3210 lsb
Ordinate axisAbscissa axis
Bit 8 Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0 LSB
Axis 7 Axis 6 Axis 5 Axis 4 Axis 3 Axis 2 Axis 1
To Next Page
Loading...
