Programming manual
CNC 8055
CNC 8055i
A.
·M· & ·EN· MODELS
SOFT: V02.2X
·449·
ISO code programming
ISO CODE PROGRAMMING
Function M D V Meaning Section
G00 * ? * Rapid traverse 6.1
G01 * ? * Linear interpolation 6.2
G02 * * Clockwise circular (helical) interpolation 6.3 / 6.7
G03 * * Counterclockwise circular (helical) interpolation 6.3 / 6.7
G04 Dwell/interruption of block preparation 7.1 / 7.2
G05 * ? * Round corner 7.3.2
G06 * Circle center in absolute coordinates 6.4
G07 * ? Square corner 7.3.1
G08 * Arc tangent to previous path 6.5
G09 * Arc defined by three points 6.6
G10 * * Mirror image cancellation 7.5
G11 * * Mirror image on X axis 7.5
G12 * * Mirror image on Y axis 7.5
G13 * * Mirror image on Z axis 7.5
G14 * * Mirror image in the programmed directions 7.5
G15 * * Longitudinal axis selection 8.2
G16 * * Main plane selection by two addresses and longitudinal axis 3.2
G17 * ? * Main plane X-Y and longitudinal Z 3.2
G18 * ? * Main plane Z-X and longitudinal Y 3.2
G19 * * Main plane Y-Z and longitudinal X 3.2
G20 Definition of lower work zone limits 3.7.1
G21 Definition of upper work zone limits. 3.7.1
G22 * Enable/disable work zones. 3.7.2
G28 * * Second spindle selection 5.4
G29 * * Main spindle selection 5.4
G28-G29 * Axis toggle 7.5
G30 * * Spindle synchronization (offset) 5.5
G32 * * Feedrate "F" as an inverted function of time. 6.15
G33 * * Electronic threading 6.12
G34 Variable-pitch threading 6.13
G36 * Corner rounding 6.10
G37 * Tangential entry 6.8
G38 * Tangential exit 6.9
G39 * Chamfer 6.11
G40 * * Cancellation of tool radius compensation 8.1
G41 * * Left-hand tool radius compensation 8.1
G41 N * * Collision detection 8.3
G42 * * Right-hand tool radius compensation 8.1
G42 N * * Collision detection 8.3
G43 * ? * Tool length compensation 8.2
G44 * ? Cancellation of tool length compensation 8.2
G45 * * Tangential control (G45) 6.16
G47 * Tool movement according to the tool coordinate system. 15.2
G48 * * TCP transformation 15.3
G49 * * Inclined plane definition 15.1
G50 * * Controlled corner rounding 7.3.3
G51 * * Look-Ahead 7.4
G52 * Movement until making contact 6.14
G53 * Programming with respect to machine zero 4.3
G54 * * Absolute zero offset 1 4.4.2
G55 * * Absolute zero offset 2 4.4.2
G56 * * Absolute zero offset 3 4.4.2
G57 * * Absolute zero offset 4 4.4.2
G58 * * Additive zero offset 1 4.4.2
G59 * * Additive zero offset 2 4.4.2
G60 * Multiple machining in a straight line 10.1
To Next Page
Loading...
