Fagor 8055 M - Page 456

·456·
Programming manual
CNC 8055
CNC 8055i
C.
·M· & ·EN· MODELS
SOFT: V02.2X
Summary of internal CNC variables.
Variables updated by the CNC once function G49 is executed.
Variables associated with machine parameters.
Work zone related variables.
Feedrate related variables.
Variables associated with function G94.
Variables associated with function G94.
Variables associated with function G94.
TOOROF R/W R/W R/W Position to be occupied by the spindle's main rotary axis.
TOOROS R/W R/W R/W Position to be occupied by the spindle's 2nd rotary axis.
Variable CNC PLC DNC
( section 13.2.5 )
MPGn R R - Value assigned to general machine parameter (n).
MP(X-C)n R R - Value assigned to (X-C) axis machine parameter (n).
MPSn R R - Value assigned to machine parameter (n) of the main spindle.
MPSSn R R - Value assigned to machine parameter (n) of the second spindle.
MPASn R R - Value assigned to machine parameter (n) of the auxiliary spindle.
MPLCn R R - Value assigned to machine parameter (n) of the PLC.
Variable CNC PLC DNC
( section 13.2.6 )
FZONE R R/W R Status of work zone 1.
FZLO(X-C) R R/W R Work zone 1. Lower limit along the selected axis (X/C).
FZUP(X-C) R R/W R Work zone 1. Upper limit along the selected axis (X-C).
SZONE R R/W R Status of work zone 2.
SZLO(X-C) R R/W R Work zone 2. Lower limit along the selected axis (X/C).
SZUP(X-C) R R/W R Work zone 2. Upper limit along the selected axis (X-C).
TZONE R R/W R Status of work zone 3.
TZLO(X-C) R R/W R Work zone 3. Lower limit along the selected axis (X/C).
TZUP(X-C) R R/W R Work zone 3. Upper limit along the selected axis (X-C).
FOZONE R R/W R Status of work zone 4.
FOZLO(X-C) R R/W R Work zone 4. Lower limit along the selected axis (X/C).
FOZUP(X-C) R R/W R Work zone 4. Upper limit along the selected axis (X-C).
FIZONE R R/W R Status of work zone 5.
FIZLO(X-C) R R/W R Work zone 5. Lower limit along the selected axis (X/C).
FIZUP(X-C) R R/W R Work zone 5. Upper limit along the selected axis (X-C).
Variable CNC PLC DNC
( section 13.2.7 )
FREAL R R R Real feedrate of the CNC in mm/min or inch/min.
FREAL(X-C) R R R Actual (real) CNC feedrate of the selected axis.
FTEO/X-C) R R R Theoretical CNC feedrate of the selected axis.
FEED R R R Active feedrate at the CNC in mm/min or inch/min.
DNCF R R R/W Feedrate selected via DNC.
PLCF R R/W R Feedrate selected via PLC.
PRGF R R R Feedrate selected by program.
FPREV R R R Active feedrate at CNC, in m/rev or inch/rev.
DNCFPR R R R/W Feedrate selected via DNC.
PLCFPR R R/W R Feedrate selected via PLC.
PRGFPR R R R Feedrate selected by program.
PRGFIN R R R Feedrate selected by program, in 1/min.