·68·
Programming manual
CNC 8055
CNC 8055i
5.
ISO CODE PROGRAMMING
·M· & ·EN· MODELS
SOFT: V02.2X
Preparatory functions
M means modal, i.e. the G function, once programmed, remains active until another incompatible
G function is programmed or until an M02, M30, EMERGENCY or RESET is executed or the CNC
is turned off and back on.
D means BY DEFAULT, i.e. they will be assumed by the CNC when it is powered on, after executing
M02, M30 or after EMERGENCY or RESET.
In those cases indicated by ?, it should be understood that the DEFAULT of these G functions
depends on the setting of the general machine parameters of the CNC.
The letter V means that the G code is displayed next to the current machining conditions in the
execution and simulation modes.
G159 * Absolute zero offsets 4.4
G210 * * Bore milling canned cycle 9.16
G211 * * Inside thread milling canned cycle. 9.17
G212 * * Outside thread milling canned cycle. 9.18
Function M D V Meaning Section
To Next Page
Loading...
