FARGO electronics PERSONA C30 - Using the Overlay; Print Area

To Next Page

To Previous Page

RESTRICTED USE ONLY Fargo Electronics, Inc.

Persona C30 Card Printer User Guide (Rev. 2.2)

5-57

Using the Overlay / Print Area

Use these Overlay / Print Area options to control both the print and overlay together or

control each individually. (Note: Determine whether to use the Frontside option (via the

Front radio button) or the Backside option (via the Back radio button).)

Step Procedure

Select For Print and Overlay for the defined area to apply to both the printing and

overlay process.

Select For Overlay Only for the defined area to apply only to the overlay process.

(Note: In this mode, printing will still be allowed over the entire card and only the

overlay will be affected.)

Select For Print Only (No Overlay) for the defined area to apply only to the print

process. (Important: In this mode, the overlay is completely disabled so it will not

be applied.)

Caution: An overlay or an overlaminate must protect dye-sublimation

printing or it will quickly begin to wear or fade.

Other manuals for FARGO electronics PERSONA C30