Name: FARGO electronics PERSONA C30
Brand: FARGO electronics
Rating: 4 (1 reviews)

To Next Page

To Previous Page

RESTRICTED USE ONLY Fargo Electronics, Inc.

Persona C30 Card Printer User Guide (Rev. 2.2)

5-97

Using the Magnetic Encoder Voltage Offset Option

Use this option to adjust the voltage of the Magnetic Encoder.

 Encoder voltage is set from the factory at a default of 7.24vdc for Hi-Co Magnetic cards

and 2.54vdc for Lo-Co Magnetic cards.

 Depending on the cards that are being used, it may be necessary to adjust the encoder

voltage out of default.

See the next two procedures for instructions on adjusting the Magnetic Encoder Voltage.

(Note: The required encoder voltage for the cards will need to be known in order to properly

set the Encoder Voltage Offset value. This information should be available through the card

manufacturer or reseller).

Other manuals for FARGO electronics PERSONA C30

Questions and Answers:

Need help?

Do you have a question about the FARGO electronics PERSONA C30 and is the answer not in the manual?

General