FARGO electronics PERSONA C30 User Manual

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C30 Card Printer User Guide (Rev. 2.2)
4-33
Resolving the Blank Output issues
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1 Review the following information.
 Symptom: A card is ejected blank (that should be printed).
 Printer Error State: None
 Driver Monitor Error Display: None
2 Run a self-test.
a. Clear any card jams.
b. Unplug power from the Printer.
c. While holding down the Pause button, reapply power.
(Note: A self-test card will be printed.)
3 Look for an image on the Ribbon.
a. After a self-test has been run, open the to front cover.
b. Remove the Print Ribbon from the Printer.
c. Visually inspect the set of panels that were last used by the Printer.
d. If an image is noticeable on the used Ribbon, continue to Step 4.
e. If an image is not noticeable on the used Ribbon, continue to Step 5.

FARGO electronics PERSONA C30 Specifications

General

Print Technology	Dye sublimation
Print Resolution	300 dpi
Card Capacity	100 cards
Connectivity	USB, Ethernet
Operating System Support	Windows 7, 8, 10
Power Requirements	100-240 VAC
Print Speed	150 cards per hour
Card Sizes	CR80 (85.6 mm x 54 mm)
Weight	12 lbs