FARGO electronics PERSONA C30 - Resolving a Ribbon RFID Error (Ribbon RFID Sensor Is Corrupted)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C30 Card Printer User Guide (Rev. 2.2)
4-11
Resolving a Ribbon RFID Error (Ribbon RFID Sensor is Corrupted)
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1 Review the following information.
 Symptom: Printer RFID Sensor does not detect a recognizable signal from
the Ribbon.
 Printer Error State: The Ribbon tag information is corrupted or incorrect.
 Driver Monitor Error Display: Ribbon RFID Error
2 Replace the Print Ribbon RFID Sensor.
a. Replace the Print Ribbon RFID Sensor.
b. Press on the Resume button.
c. If the error continues, replace the Printer Main Board.