RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C30 Card Printer User Guide (Rev. 2.2)
3-1
Section 3: Setup and Installation
Procedures
The following guide will walk you through the installation of the Persona C30 Card Printer
Driver.
Time Requirement (software): This software installation process will require
approximately 2 to 5 minutes (depending on the speed of your PC).
Time Requirement (Printer): The time required to set up a standard Persona C30
Printer would be approximately 5 to 10 minutes.
The System Requirements are as follows:
IBM-PC or compatible, Windows® 98SE, Me/2000/XP, Pentium® class 233MHz computer
with 64MB of RAM or higher, 200MB free hard disk space or higher, USB 1.1
Printer Setup and Installation
Choosing A Good Location
Follow these guidelines:
Place the unit in a location with adequate air circulation to prevent internal heat build up.
Use the Printer's dimensions as a guideline for the minimum clearances to the unit.
(Note: Allow for adequate clearance in front of the unit to accommodate the unit with its
Covers open.)
Do not install unit near heat sources such as radiators or air ducts or in a place subject
to direct sunlight, excessive dust, mechanical vibration or shock.
About Moisture Condensation
If the unit is brought directly from a cold to a warm location or is placed in a very damp room,
moisture may condense inside the unit. Should this occur, print quality may not be optimum.
Leave the unit turned OFF in a warm, dry room for several hours before using. This will allow
the moisture to evaporate.
To Next Page
Loading...
