RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C30 Card Printer User Guide (Rev. 2.2)
5-104
Using the Flipper Smart Angle Offset Option
Use this option to change the Flipper angle relative to the default smart card loading position.
This is done in order to adjust travel to and from the Flipper and the Smart Card Docking
Module.
Step Procedure
1 Enter a negative value to decrease the amount of Flipper angular movement
from the home position to the smart card loading position.
Or
Enter a positive value to increase the amount of Flipper angular movement from
the home position to the smart card loading position.
(Maximum Adjustment Range: The maximum adjustment range is 5. 1 is
approximately 1 degree.)
To Next Page
Loading...
