RESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C30 Card Printer User Guide (Rev. 2.2)
iv
Resolving a No Ribbon Installed Error________________________________________________ 4-22
Resolving a Invalid Ribbon Error____________________________________________________ 4-24
Resolving a Wrong Ribbon Error____________________________________________________ 4-26
Resolving a Card Jam Error ________________________________________________________ 4-28
Resolving a Headlift Motor or Sensor Error____________________________________________ 4-30
Resolving the Cover Open Error Message _____________________________________________ 4-32
Resolving the Blank Output issues___________________________________________________ 4-33
Flipper Table Module Assembly Problems_______________________________________________ 4-36
Resolving the No Flipper Table Module problem _______________________________________ 4-36
Resolving the Flipper Jam Error_____________________________________________________ 4-37
Diagnosing Image Problems __________________________________________________________ 4-39
Resolving the Pixel Failure problems_________________________________________________ 4-39
Resolving the Card Surface Debris problems___________________________________________ 4-40
Resolving the Incorrect Image Darkness problems ______________________________________ 4-41
Resolving Ribbon Wrinkle problems _________________________________________________ 4-43
Resolving the Excessive Resin Printing problems _______________________________________ 4-45
Resolving the Incomplete Resin Printing problems ______________________________________ 4-47
Resolving the Image Placement problems _____________________________________________ 4-48
Resolving the Poor Image Quality problems ___________________________________________ 4-51
Running the Self Test _______________________________________________________________ 4-52
Running the Standard Self Test Print _________________________________________________ 4-53
Running the Magnetic Self Test (HiCo Only) __________________________________________ 4-54
Section 5: Printer Adjustments_______________________________________________5-1
Table of Contents ___________________________________________________________________ 5-1
Safety Messages (review carefully)______________________________________________________ 5-4
C30 Print Driver Options _____________________________________________________________ 5-5
Reviewing C30 Printer Drivers ______________________________________________________ 5-5
Reviewing C30 Printer Drivers ______________________________________________________ 5-5
Using the Card tab (Persona C30)_______________________________________________________ 5-6
Adjusting the Card Size Option ______________________________________________________ 5-6
Adjusting the Orientation Option _____________________________________________________ 5-7
Selecting the number of copies_______________________________________________________ 5-8
Using the Diagnostics button under the Card tab _________________________________________ 5-9
Using the Clean Printer Option______________________________________________________ 5-10
Using the Test Print button_________________________________________________________ 5-12
Using the About button____________________________________________________________ 5-13
Using the Device Options tab (C30) ____________________________________________________ 5-14
Reviewing the Device Options tab ___________________________________________________ 5-14
Adjusting the Ribbon Type option ___________________________________________________ 5-15
Selecting the Auto Ribbon Select option ______________________________________________ 5-16
Using the new Printer Driver (Version 2.1.5)___________________________________________ 5-17
Changing the Color Profile Selection for the C30 _______________________________________ 5-18
Adjusting the Color Matching option_________________________________________________ 5-20
Adjusting for the Resin Dither ______________________________________________________ 5-21
Using the Print Both Sides option____________________________________________________ 5-22
Using the Split 1 Set of Ribbon Panels option __________________________________________ 5-23
Using the Print Back Side First option ________________________________________________ 5-24
Using the Print Back Side Only option________________________________________________ 5-25
Using the Rotate Front 180 Degrees or Rotate Back 180 Degrees options ____________________ 5-26
Using the Disable Printing option____________________________________________________ 5-27
Using the Image Color tab (C30) ______________________________________________________ 5-28
Using the Resin Heat (K) option (Front and Back) ______________________________________ 5-29
Using the Overlay Heat (O) option___________________________________________________ 5-30
Using the Color Matching option and Default button_____________________________________ 5-31
Using the Calibrate tab (Persona C30) __________________________________________________ 5-32
To Next Page
Loading...
