OPERATION ST100A Series Flow Meter
70 Fluid Components International LLC
Command 151: Read Calibration Flow Limits
See Table 17, page 74, for response code list.
Note: 1. S
end Command 159 with no data to reload the instrument’s factory default programming.
Command 154: Read Calibration Temperature Limits
Temperature Lower Limit Value
Temperature Upper Limit Value
See Table 17, page 74, for response code list.
Command 157: Read Calibration Pressure Limits
Pressure Lower Limit Value
Pressure Upper Limit Value
See Table 17, page 74, for response code list.
Command 159: Write Factory Restore
See Table 17, page 74, for response code list.
Command 160: Write (4-20 mA) Output Channel #1 Parameters
D/A Setting for 4 mA Out (OUTZ1)
D/A Setting for 4 mA Out (OUTF1)
D/A Setting for 4 mA Out (OUTZ1)
D/A Setting for 4 mA Out (OUTF1)
See Table 17, page 74, for response code list.
Command 161: Read (4-20 mA) Output Channel #1 Parameters
D/A Setting for 4 mA Out (OUTZ1)
D/A Setting for 4 mA Out (OUTF1)
See Table 17, page 74, for response code list.
To Next Page
Loading...
Need help?
General
