9 Measurement
FLUXUS F60* 9.1 Parameter input
85
UMFLUXUS_F60xV5-0EN, 2017-10-16
Sound speed of the lining material
• Enter the sound speed of the lining material.
• Press ENTER.
These displays will only be indicated if Other Material is selected.
Lining thickness
• Enter the thickness of the lining.
• Press ENTER.
This display will only be indicated if yes is selected in the menu item Lining.
Pipe roughness
The flow profile of the fluid is influenced by the roughness of the inner pipe wall.
The roughness is used for the calculation of the profile correction factor.
In most cases, the pipe roughness cannot be exactly determined and must therefore be
estimated.
For the roughness of some materials, see annex C.
• Enter the roughness for the selected pipe or lining material.
• Change the value according to the condition of the inner pipe wall.
• Press ENTER.
Parameter\Lining\Other Material\c-Material
For pipe materials there are 2 sound speeds, the longitudinal and the transversal
one. Enter the sound speed which is nearer to 2500 m/s.
Parameter\Liner Thickness
Parameter\Roughness
To Next Page
Loading...
