Flexim FLUXUS F60 Series - Page 99

9 Measurement
FLUXUS F60* 9.2 Measurement settings
99
UMFLUXUS_F60xV5-0EN, 2017-10-16
9.2.4 Activation of an analog output
• Select the channel for which an output is to be activated in the program branch Output
Options.
• Press ENTER.
• Press ENTER until Current Loop is displayed. Select yes to activate the output.
• Press ENTER.
Output Options
for Channel …
ENTER until
Current Loop
Meas.Values
Zero-Scale Val.
Full-Scale Val.
Test output
Error-val. delay
see annex A, p. 224
Notice!
An output can only be activated in the program branch Output Options if it has
previously been installed.
Output Options\for Channel A:
Output Options\...\Current Loop