Control Panel
61
Product Overview
2
18 Numeric keypad
Use the numeric buttons on the keypad to enter the number of copies, passcodes, and
other numerical values.
19 <Custom Button 1> (Copy)
"Copy" is assigned to this button by default.
Press this button to display the [Copy] screen.
z
For information on how to assign a service to the button, refer to "Before Using the Machine" > "Customizing the Control Panel" >
"Assigning Services to the Custom Buttons" in the Administrator Guide.
20 <Custom Button 2> (Fax)
"Fax" is assigned to this button by default.
Press this button to display the [Fax] screen.
z
The Fax Kit (optional) must be installed to use this button for Fax service.
z
For information on how to assign a service to the button, refer to "Before Using the Machine" > "Customizing the Control Panel" >
"Assigning Services to the Custom Buttons" in the Administrator Guide.
21 <Custom Button 3> (Review)
"Review" is assigned to this button by default.
On the [Review] screen, you can check a list of the status of Copy, Fax, and Scan services
whose settings have been changed from the defaults. You can also check the details of fax
and e-mail recipients.
z
For information on how to assign a service to the button, refer to "Before Using the Machine" > "Customizing the Control Panel" >
"Assigning Services to the Custom Buttons" in the Administrator Guide.
22 USB memory slot
Insert a USB 2.0 memory device directly here.
z
A memory card reader cable or a USB memory device cable cannot be directly connected to the machine. Use
the USB Hub (optional) to connect a memory card reader or a USB memory device cable.
z
This feature is not available for some models. An optional component is required. For more information,
contact our Customer Support Center.
23 Paper clip tray
Used for placing paper clips and staples.
24 One-touch panels (Only available for machines with the Fax service)
Contains the one-touch buttons.
Turn over the panels to display buttons 1 - 70, M01, and M02.
There are two ways in which address numbers and stored programs are assigned to the
one-touch buttons. Select either of the following:
z
[Type 1]
The buttons 1 to 70 are used for address numbers and they correspond to the registered
address numbers 0001 to 0070, while the buttons M01 and M02 are used for stored
programs and they correspond to the registered stored programs 1 and 2.
z
[Type 2]
To Next Page
Loading...
Need help?
General
