Chapter 1 Overview
1.2 The Command Syntax
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
23
• Volume name
A volume name must be specified when creating a volume. For details about the syntax, refer to "1.2.4
Alias Name Syntax" (page 20). Some commands accept a comma-separated list of volume names. A
volume name and a volume number cannot both be specified in the same command. Do not include
spaces before or after commas.
1.2.10 Host Syntax
There are two methods to specify a host identifier; a host number or a host name.
• Host number
A host number is automatically created by the system when a host identifier or a host alias is registered.
This is a decimal number.
The following types of host identifier are available:
- Host WWN name (FC)
- SAS address (SAS)
- iSCSI host name (iSCSI)
The identifier can be displayed by using the following commands:
- "show host-wwn-names"
- "show host-sas-addresses"
- "show host-iscsi-names"
Host numbers may be combined as follows:
- A single host number: 1
- A list of host numbers: 2,3
- A hyphenated range of host numbers from a to z: 2-5
- A list of host numbers, host ranges, or both, separated by commas. Spaces are not permitted before or
after commas: 1,3,10-12
• Host name
A host alias must be specified when registering a host identifier. For details about the syntax, refer to
"1.2.4 Alias Name Syntax" (page 20)
. Some commands accept a comma-separated list of host names. A
host name and a host number cannot both be specified in the same command. Do not include spaces
before or after commas.
Two or more parameters might not be able to be specified for several commands. For details, refer to the
command descriptions.
Two or more parameters might not be able to be specified for several commands. For details, refer to the
command descriptions.
To Next Page
Loading...
