Fujitsu Eternus DX90 S2 - Stop Advanced-Copy

Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management > stop advanced-copy
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
400
stop advanced-copy
This command stops an Advanced Copy session or sessions. All types of copy sessions can be stopped.
■ Syntax
■ Parameter
■ Example(s)
stop advanced-copy -session-id session_ids [-delete-mode {forced|normal}]
-session-id This parameter specifies the session IDs that are to be stopped. One or more numbers can be
specified at the same time.
Example:
-session-id 0 (Only 0)
-session-id 0,1 (0 and 1)
-session-id 2-5 (2 to 5)
-session-id 0,2-5 (0, and 2 to 5)
-delete-mode
Optional. This parameter specifies the deletion mode. This parameter can be specified for any
type of Advanced Copy session. If "forced" is specified, the specified session and all the sessions
before the specified session are forcibly deleted. If omitted, this parameter is handled as
though "normal" is specified. When multiple sessions are specified, this parameter is applied
to all the selected sessions.
forced Sessions are forcibly deleted.
normal Sessions are not forcibly deleted (default).
The following example forcibly stops Advanced Copy session ID #1:
CLI> stop advanced-copy -session-id 1 -delete-mode forced