Fujitsu Eternus DX90 S2 - Set Flexible-Tier-Sub-Pool

Chapter 3 Configuration Settings and Display
3.2 Flexible Tier Management > set flexible-tier-sub-pool
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
99
set flexible-tier-sub-pool
This command changes the information for the Flexible Tier Sub Pools (FTSPs) that are already registered in
the ETERNUS DX Disk storage system.
■ Syntax
■ Parameter
set flexible-tier-sub-pool {-ftsp-number ftsp_number | -ftsp-name ftsp_name }
[-assigned-cm{0|1|cm0cpu0|cm0cpu1|cm1cpu0|cm1cpu1|cm2cpu0|cm2cpu1|cm3cpu0|cm3cpu1|
cm4cpu0|cm4cpu1|cm5cpu0|cm5cpu1|cm6cpu0|cm6cpu1|cm7cpu0|cm7cpu1|auto}]
-ftsp-number
or
-ftsp-name
This parameter specifies the FTSP identifier. Only one FTSP identifier can be specified in a
single command.
-assigned-cm
Optional. This parameter specifies the assigned CM for the RAID group that is added to the
target FTSP. When "auto" is specified, the assigned CM is automatically determined by the
ETERNUS DX Disk storage system. If omitted, the assigned CM is not changed.
For the ETERNUS DX80 S2/DX90 S2:
0 Controller module#0
1 Controller module#1
auto Automatically (default)
For the ETERNUS DX410 S2/DX440 S2 and ETERNUS DX8100 S2:
cm0cpu0 Controller module#0 CPU#0
cm0cpu1 Controller module#0 CPU#1
cm1cpu0 Controller module#1 CPU#0
cm1cpu1 Controller module#1 CPU#1
auto Automatically (default)