Fujitsu Eternus DX90 S2 - Appendix E Default Value List

ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
750
Appendix E
Default Value List
The default values for commands are shown below.
Table E.1 List of the default values for Eco-mode management commands
Table E.2 List of the default values for host interface management commands
Command Parameter Default value
set eco-mode mode disable
create eco-schedule event-type every-day
Command Parameter Default value
set fc-parameters host-affinity disable
connect FC-AL
rate auto
loop-id-assign manual
loop-id 0x00
frame-size 2048 bytes
reset-scope initiator-lun
reserve-cancel disable
rec-line-no 0
rec-transfer-sync enable
rec-transfer-stack enable
rec-transfer-consistency enable
rec-transfer-through enable
set sas-parameters host-affinity disable
rate auto
reset-scope initiator-lun
reserve-cancel disable
set iscsi-parameters host-affinity disable
reset-scope initiator-lun
reserve-cancel disable
ipv4-flag enable
ipv6-flag disable
link-local-ip The IP address that is generated from the
ETERNUS Disk storage system WWN
tcp-port 3260
tcp-window-scale 2
congestion-control-option enable
isns-server disable