Fujitsu Eternus DX90 S2 - Page 321

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-group
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
321
■ Example(s)
-add-host-number
or
-add-host-name
or
-release-host-number
or
-release-host-name
Optional. This parameter specifies the host that is to be added or deleted. Two or more
parameters can be specified by separating them with a comma.
Example: -add-host-number 1,2
For details, refer to "1.2.10 Host Syntax" (page 23)
.
The following example changes the host group named "HG001". The new name is "NEW_HG002". The host
response number is changed to 2:
CLI> set host-group -host-group-name HG001 -host-response-number 2 -name NEW_HG002
The first command will create the host group named "HG0001". Host numbers 1 and 2 belong to this host
group. The second command will add other definitions to the host group. Host number 3 and host numbers
5 to 7 are specified for the host group:
CLI> create host-group -host-group-name HG0001 -host-number 1,2
CLI> set host-group -host-group-name HG0001 -add-host-number 3,5-7