Chapter 3 Configuration Settings and Display
3.1 Thin Provisioning Pool Management > create thin-pro-pool
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
75
-capacity Optional. This parameter specifies the disk capacity that is used to create a RAID group. This
parameter can only be specified when "-rg-mode auto" is selected.
-disks Optional. This parameter specifies which disks are used to configure the RAID group. This
parameter can only be specified when "-rg-mode manual" is selected. One or more disks can
be specified at the same time. For details, refer to "1.2.3 Disk Syntax" (page 19)
.
-assigned-cm
Optional. This parameter specifies the assigned controller for the specified RAID group. This
parameter can only be specified when "-rg-mode manual" is selected. If "auto" is specified, the
fixed controller, which is calculated automatically by the system, is assigned. If this parameter
is omitted, "auto" mode is selected.
For the ETERNUS DX80 S2/DX90 S2:
0 Controller module #0
1 Controller module #1
auto Automatically (default)
For the ETERNUS DX410 S2/DX440 S2 and ETERNUS DX8100 S2:
cm0cpu0 Controller module#0 CPU#0
cm0cpu1 Controller module#0 CPU#1
cm1cpu0 Controller module#1 CPU#0
cm1cpu1 Controller module#1 CPU#1
auto Automatically (default)
For the ETERNUS DX8700 S2:
cm0cpu0 Controller module #0 CPU#0
cm0cpu1 Controller module #0 CPU#1
cm1cpu0 Controller module #1 CPU#0
cm1cpu1 Controller module #1 CPU#1
cm2cpu0 Controller module #2 CPU#0
cm2cpu1 Controller module #2 CPU#1
cm3cpu0 Controller module #3 CPU#0
cm3cpu1 Controller module #3 CPU#1
cm4cpu0 Controller module #4 CPU#0
cm4cpu1 Controller module #4 CPU#1
cm5cpu0 Controller module #5 CPU#0
cm5cpu1 Controller module #5 CPU#1
cm6cpu0 Controller module #6 CPU#0
cm6cpu1 Controller module #6 CPU#1
cm7cpu0 Controller module #7 CPU#0
cm7cpu1 Controller module #7 CPU#1
auto Automatically (default)
To Next Page
Loading...
