176
Chapter 6 High Reliability Tools
● Power Supply Monitoring
ServerView monitors the power supply. In an environment where ServerView is not applied, power
supply irregularities cannot be detected during operation. In order to detect the problem, the server must
reboot to run the BIOS Setup Utility or the Server Management Tools. System stops due to power supply
failures cannot be prevented.
6.2.1 Installing ServerView
● When Installed Using ServerStart
If the OS is installed using ServerStart, ServerView will be installed at once with the OS and other high
reliability tools.
● When Installed Manually (Linux)
ServerView cannot be installed using ServerStart. To install ServerView manually into a Linux system,
refer to "Installing" in "ServerView User’s Guide".
Be sure to install SNMP service before installing ServerView.
■ When an error screen appears after ServerView installation
(Windows Server 2003 only)
If Windows Server 2003 Service Pack 1 is applied, the following message may appear on restarting after
installing/uninstalling ServerView.
There is no problem with operations. Click [Close Message] to close the message.
6.2.2 Setting Required after Installation
Perform necessary operations after ServerView installation referring to "2.4 Checking after Installation"
in "ServerView User’s Guide".
■ Boot Monitoring Setting
We recommend enabling the "Boot Monitoring" function after ServerView is installed. For setting
procedures and explanation on the function, refer to "[Restart Settings] Tab" of "3.4 Serious Error
Handling (ASR)" in "ServerView User’s Guide".
In order to protect the computer, this program is terminated by
Windows.
Name: SNMP Service
To Next Page
Loading...
