Fujitsu Primergy RX300 S3 - How to Install Internal Hard Disk Units

206
Chapter 7 Installing Internal Options
■ Correspondence between the Hard Disk Bay Number and the Slot
Number
The correspondence between the hard disk bay number and the slot number is as follows.
7.6.3 How to Install Internal Hard Disk Units
1 Turn off the server and all peripheral devices. Also unplug all power cables from
the server.
"1.4.3 Turning Off the Server" (pg.33)
2 Touch a metal part of the server to discharge static electricity.
3 Remove the dummy unit from the bay where the internal hard disk unit is to be
installed.
Dummy units are installed in bays where no internal hard disk units are installed. Draw forward
the dummy unit slowly while pushing the tab inwards. Keep the removed dummy unit.
4 Install the internal hard disk unit in the 3.5-inch storage bay.
1. Insert the internal hard disk unit in the 3.5-inch storage bay with its handle raised.
2. Insert firmly by lowering the handle.
Bay
number
Standard installation 1 2 3 4 5 6
When an internal backup device
is installed
1--456
Slot Number 012345
Dummy units
Press both tabs inwards
Handle