187
PRIMERGY RX300 S3 User's Guide
7
Installing Internal Options
7 Install the CPU.
1. Align the No.1 pin mark (a small triangle) of the CPU socket with the triangle mark
of the CPU, and install the CPU.
2. Close the socket cover to secure the CPU to the CPU socket.
8 Install the heat sink.
Install the heat sink on the CPU with screws.
Tighten the screws little by little diagonally.
9 Reattach the fan duct and the top cover.
"7.2 Installing/Removing the Top Cover" (pg.182)
10 Push the server back into the rack.
• When installing the CPU, be careful not to bend the pins of CPU socket.
Triangle mark
CPU
Heat sink
To Next Page
Loading...
