298
Appendix
■ Connecting the Server to a PC
Connect the server to a PC using an RS-232C cross cable.
This server has two serial ports. Connect the cable to Serial Port 1.
■ Configuring the Terminal Software (PC)
Perform settings for the remote control function using terminal software on the PC.
● Port Configuration
Configure the port on the PC as follows:
(Window example)
table: Port Settings
Item Contents
Bits per second 9600
Data bits 8
Parity Not applied
Stop bits 1
Flow control Not applied
Server Rear
PC Rear
RS-232C cross cable
Serial Port
Serial Port
To Next Page
Loading...
