72
Chapter 3 OS Installation Using ServerStart
2 Click [Start now].
Clicking [Start now] deletes all disk contents and starts installation. Click [Stop] when you do
not perform installation.
After 10 seconds, installation starts automatically.
1. When RAID has been configured, the system restarts.
2. If a message prompts you to insert the Array Controller Document & Tool CD, insert
the CD-ROM and click [OK].
3. If a message prompts you to insert the PRIMERGY Document & Tool CD, insert the
CD and click [OK].
4. If a message prompts you to insert the Service Pack CD-ROM, insert the CD-ROM
and click [OK].
5. For Windows Server 2003 x64, a message prompts you to insert the ServerStart
Disc 2 and restart the system. Insert the ServerStart Disc 2 and restart the system.
3 When a message prompts you to insert the OS CD-ROM, insert the CD-ROM
and click [OK].
For Windows 2000 / Windows Server 2003 / Windows Server 2003 x64
Insert the OS CD-ROM (Installation CD-ROM).
For Windows Server 2003 R2 / Windows Server 2003 R2 x64
Insert the OS CD-ROM (Installation CD-ROM) Disc 1. If a message prompts you to insert the
Disc 2, eject the Disc 1 and insert the OS CD-ROM (Installation CD-ROM) Disc 2.
After files are copied, a message prompts you to insert the ServerStart CD-ROM.
4 Insert the ServerStart CD-ROM and click [OK].
The License Agreement window appears.
5 Click [I agree].
After files are copied, a message prompts you to eject the CD-ROM and floppy disk.
6 Eject the CD-ROM and floppy disk and click [OK].
Then the system is restarted.
The system continues the installation operation after restart.
OS GUI setup, LAN utility installation, Service Pack installation, and Active Directory
installation are performed automatically.
7 When a confirmation message to restart appears, click [Restart].
The system restarts and installs high reliability tools.
8 When a message on installation completion appears, press any key.
9 Restart the system.
Click [Start] → [Shutdown]. Select [Restart] and click [OK].
The system restarts.