EasyManua.ls Logo

FUTABA 6k - Contents and Technical Specifications; System Compatibilty

FUTABA 6k
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Before use
15
CONTENTS AND TECHNICAL SPECIFICATIONS
(Specications and ratings are subject to change without notice.)
SYSTEM COMPATIBILITY
Your 6K includes the following components:
• T6K transmitter for airplanes or helicopters
• R3006SB Receiver
• Switch harness
*The set contents depend on the type of set.
Transmitter T6K
(2-stick, 6-channel, T-FHSS Air-2.4G system)
Transmitting frequency: 2.4GHz band
System: T-FHSS Air, S-FHSS, switchable
Power supply: 6.0V Dry battery
Receiver R3006SB
(T-FHSS Air-2.4G system, dual antenna diversity, S.BUS, S.BUS2 system)
Power requirement: 4.8V~7.4V battery or regulated output from ESC, etc. (*1)
Size: 1.7 x 0.98 x 0.35 in. (43.1 x 25.0 x 8.8 mm)
Weight: 0.3 oz. (8.5g)
Battery F/S Voltage: It sets up with a transmitter
(*1) When using ESC's make sure that the regulated output capacity meets your usage application.
The
6K
is a
2.4GHz T-FHSS Air system
. The transmitter can also be switched to
S-FHSS
. (However, the telemetry
system cannot be used with S-FHSS.) The usable receivers are shown below.
NOTE:
*The Futaba
T-FHSS Air
system cannot be used with Futaba
S-FHSS/FASST/FASSTest
systems. Use
it with a
T-FHSS Air
system transmitter and receiver. The
T6K
is a
T-FHSS Air system
, but can also
be used with an
S-FHSS
receiver by switching to
S-FHSS
. However, in this case the telemetry system
cannot be used.
*The
T-FHSS Air system
and
T-FHSS
surface system are different. The
T6K
cannot be used with the
R304SB, R304SB-E
or
T-FHSS
surface system receivers.
Communications System
Usable Receivers
T-FHSS Air
(Default)
R3006SB, R3008SB
*R304SB, R304SB-E, T-FHSS surface system
receivers do not operate.
S-FHSS 
(Change is possible)
R2008SB
R2006GS
R2106GF

Table of Contents

Related product manuals