FUTABA 6k - Battery Installation and Charging Guide

Before use
19
Battery Replacement Method
Slide the battery cover o󱐯 the
transmitter in the direction of
the arrow in the gure.
Slide the battery cover
back onto the case.
Load the new AA size
batteries. Pay very close
attention to the polarity
markings and reinsert
accordingly.
Push
Battery Cover
INSTALLATION AND REMOVAL OF THE T6K BATTERY
The T6K transmitter is designed to work with either four (4) AA alkaline dry cell batteries, or
HT5F1800B battery pack, both available separately. The transmitter batteries used are a matter of personal
preference. AA Alkaline batteries are available at any local hobby shop, grocery store, etc. A battery pack
will need to be purchased from a hobby shop.
CAUTION
Always be sure you reinsert the batteries in the correct polarity order.
If the batteries are loaded incorrectly, the transmitter may be damaged.
When the transmitter will not be used for any short or long period of time, always remove the
batteries.
If the batteries do happen to leak, clean the battery case and contacts thor-
oughly. Make sure the contacts are free of corrosion.
Check:
Turn the power switch on the transmitter to the ON position.
Check the battery voltage display on the LCD screen. If the
voltage is low, check the batteries for insufcient contact in
the case or incorrect battery polarity.
Disposal of the Dry Cell Batteries:
The method to dispose of used dry cell batteries depends on
the area in which you reside. Dispose of the batteries in ac
-
cordance with the regulations for your area.