SENSOR
Sensor
(Common)
This screen registers the telemetry sensors used
with the transmitter. When Futaba SBS-01T/E,
SBA-01RO/RM/RB and SBS-01A sensor is used,
this setting is unnecessary and the sensor can be
used by simply connecting it to the S.BUS2 port of
the receiver.
When using sensor to which the slot number
was changed by other transmitters or Robbe sensor
(TEMP125, VARIO-1712, 1672), they must be
registered here.
[What is a slot?]
Servos are classied by CH, but sensors are classied in units called "slot". There are slots
from No. 1 to No. 31. Altitude sensors units may use multiple slots.
T6K can use 1 of temperature, RPM and altitude sensor respectively. Any more sensor can't
be used.
● The "SENSOR" of a menu is chosen, and Jog key
press.
● The kind of sensors.
● SBS-01RO, SBS-01RM, SBS-01RB is used.
● SBS-01T, SBS-01TE is used.
● OFF → R3008SB：EXT battery voltage can be indicated.
Method
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
② Select
from the menu with the Jog
key.
③ Open the setting screen by
pressing the Jog key.
（1 second）
Calling the setting screen
"SENSOR"
① In the SENSOR screen state, select
(sensor) from the menu with the
Jog key.
② Select the sensor by pressing
the + key or – key.
Change the sensor
＋ －
or
● R3008SB Receiver, CA-RVIN-700 (external voltage input cable sold
separately) is necessary.
● Soldered wiring work is necessary.
To Next Page
Loading...
