FUTABA 6k - Flight Modes and Center Alarm

152
Multicopter
Function
Method
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
＋
② Select
from the menu with the
Jog key.
③ Open the setting screen by
pressing the Jog key.
（1 second）
Calling the setting screen
This flight mode is used for a controller of the
multi-copter connected to 6CH.
4 can be changed to a flight mode by the
chosen switch. It's used in case of a controller of
a multicopter of the type to which the ight mode
can be changed.
"FLY MOD"
FLY MOD
Flight mode
(MULTICOPT)
■ Activating the function
＋ －
or
① Select the "INH" item of the
condition you want to use and
then set that ight mode to "ON"
or "OFF" by pressing the + key or
– key.
● Set conditions you do not want to use to "INH".
（Changing the switch）
■ Switch selection
＋ －
or
② Change the switch by
pressing the + key or
– key at the switch
selection item.
Range：SwA ～ SwD
Default：SwA
■ Switch direction
＋ －
or
③ Select the ON direction
by pressing the + key or
– key at the ON direction
selection item.
Range：
● 2P SW：NULL, UP, DOWN
● 3P SW：NULL, UP, UP&D, UP&C, CNTR, C&DN,
DOWN
Flight mode
Flight mode
● NOR is setting of CH6
of the state that SW is
off. 0 is usually used in
this state neutrally. Even
if the numerical value
is changed in case of
INH, movement doesn't
reect 1-4.
● Priority is given to the
mode 2 when the mode
1 and 2 is turned on
simultaneously.
（Activating the function） （Switch direction）
（Switch selection）
● When not using this Function
select INH. The display of
On/O󱐯 is shown when active
and assigned to a switch.
● Select the setting item
with the Jog key.