FUTABA 6k - How to Turn Transmitter Power ON;OFF; Adjusting Display Contrast

Before use
23
*If THR stick is high, the next WARNING screen will come out. Moreover, if a power supply
is switched on while SW set by WARNING setup has been ON, it will be indicated by
WARNING.
（
In the case of Multicopter mode, throttle position alarm does not occur. )
Power OFFPower ON
Throttle Stick Slow
Power Switch
Power Switch
1. Turn on the transmitter power switch.
2. Turn on the receiver or speed control power switch.
Always be sure the motor/engine is stopped.
1. Turn o󱐯 the receiver or speed control power switch.
2. Then turn o󱐯 the transmitter power switch.
ON
OFF
OFF
ON
Turning on the power switches
If the power switches are turned o󱐯 in the opposite order the model may unexpectedly run out of control and
cause a very dangerous situation.
Turning o the power switches
How to turn transmitter power ON/OFF
When turning on the power, the T6K transmitter will begin emitting RF automatically after it conrms
the surrounding RF conditions. The status of the transmitter is displayed by LED at the upper part of the
front of a T6K.
ADJUSTING DISPLAY CONTRAST
To adjust the display contrast, from the home menu press and hold the END BUTTON.
Push the
＋－
KEY while still holding the END BUTTON:
＋
KEY to brighten
－
KEY to darken the display
END ＋
END －
Brighten
Darken