① Select the "SPEECH-VOLUME" item and change the
volume by pressing the + key or – key.
＋ －
or
Selection range：
HIGH, LOW
Speech volume
●
Parameter
setting is
not reset. However,
STK POSI ALRM,
and the Telemetry
mode on which (M)
was displayed are
resettable.
Stick position alarm
An alarm (single beep) can be sounded at the specied throttle stick position.
● Alarm function ON/OFF can be set by switch.
Select "Parameter"
Press the Jog key to the side and select page 4.
Beep sounds
When the THR stick
is set to the
specified position.
（STK POSI ALRM ）
● Select the item with the
Jog key.
INH ⇔ ON/OFF
Switch selsction
Switch direction
Stick position
● When INH is selected, the
function cannot be
used. When ON or
OFF is selected, the
function is activated.
ON and OFF changes are
linked to the switch.
● The number in parenthesis
is the current throttle stick
position.
① Stick position is chosen by Jog
key.
② Set the throttle stick to the
position at which you want to
generate the alarm.
③ When the Jog key is held
down the alarm sounds at that
position.
Memorize the position at
which the beep is to sound.
THR Stick
ON
To Next Page
Loading...
