Gap Diagnostic IIDTool - Engine (L316-12 with DSC); Steering Angle Sensor Calibration; Active Damping (L322-10); Suspension

To Next Page

To Previous Page

104 105

IIDTool

User Manual : Version 33, Firmware V3.0

Preparations

•TurnengineOFF

•Selectneutral,depressandholdbrakepedal

•Starttheroutineandfollowinstructionsonscreen

Usages

This function is used when:

•Thesensorisreplaced

•ThetransferboxECUisreplacedorre-ashed

4.6.6 Engine (L316-12 with DSC)

Steering angle sensor calibration

This routine will calibrate the steering angle sensor centre position.

Preparations

•Placethevehicleonaatandlevelsurface.

•Ensurethatyourfrontwheelsandsteeringwheelarestraightbeforeproceeding.

Usages

This function is used when:

•Thesteeringanglesensorisreplaced.

•Awheelalignmentisperformedonthevehicle.

•Itmayberequiredifpartsofthesteeringsystemhavebeenreplacedorremoved.

4.6.7 Active Damping (L322-10)

Needed when the active damping ECU is replaced or updated.

4.6.8 Suspension

For baseline calibration, the standard function allows changes to each corner individually, Front Left,

Front Right, Rear Left and Rear Right.

This is only required when height sensors, linkages or any parts related to height measuring

are replaced or reinstalled. It may also be needed after a wheel alignment. For height changes,

raising or lowering the vehicle, please refer to the Height function (section 4.4).

Other manuals for Gap Diagnostic IIDTool