Gap Diagnostic IIDTool - Battery Replacement (L322-10, L319-10, L320-10, L550); Deactivate Valet Mode (L322-10, L319-10, L320-10); Transport Mode Activation, Deactivation (L322-02, L322-06); ECU Renew (L322-02, L322-06)

To Next Page

To Previous Page

128 129

IIDTool

User Manual : Version 33, Firmware V3.0

Battery Replacement (L322-10, L319-10, L320-10, L550)

This routine will reset the stored battery monitoring data.

Usage

This routine is required after the battery is replaced.

Deactivate Valet Mode (L322-10, L319-10, L320-10)

This routine will return the vehicle from valet to normal mode. This is useful when the PIN is unknown

and the vehicle is in valet mode.

Transport Mode activation, deactivation (L322-02, L322-06)

This routine will allow activation or deactivation of the transport mode for both the BPM Body Processor

and LCM Light Control ECU’s.

ECU renew (L322-02, L322-06)

ThisroutineisusedwhenreplacingtheBodyProcessorECUortoxcorruptedcodingdata.

Crash Status Reset (L359 up to 2012)

This routine is used following a crash.

Driver/Passenger Door Glass Learn (L319-10, L320-10, L359, L322-10)

ThisroutineisrequiiredwhentheDriverand/orPassengerdoorECUisupdated.

4.7.9 Airbag (L322-10, L319, L320, L538)

Set Normal Mode

This routine is used when the Airbag ECU is replaced following a crash (crash logs cannot be erased).

It will initialize the ECU and set it to normal mode.

4.7.10 HVAC Heat / Cool

Learn Actuator Limits (L322-10, L319-10, L320-10)

This routine is used when an actuator is removed or replaced. It is also required when the HVAC ECU

is replaced.

Stepper motor initialization (L319-10, L320-10, L405, L494)

This routine is used when a stepper motor is removed or replaced. It is also required when the HVAC

ECU is replaced.

Set HVAC for AHCM (L322-10)

This routine is required in order to use the AHCM Auxiliary Heater routines on these vehicles. It

only needs to be performed once.

Other manuals for Gap Diagnostic IIDTool