Gap Diagnostic IIDTool - Body Control;Processor; Key Programming (VIN Locked L319-04, L320-05)

126
IIDTool
GAP Diagnostic 2019-07-15 All Rights Reserved
User Manual : Version 33, Firmware V3.0
4.7.8 Body Control/Processor
Key programming (VIN locked L319-04, L320-05)
Preparations
• Have all keys on hand including new keys
• Unlock the doors
• Close all doors including the tailgate
Instructions
A previously programmed key is required to start the process. II When calling the function, the IIDTool
will start displaying messages to guide you:
• “Each key is programmed at position 1 (accessory) <+>”
• “When completed turn last key at position 2 (ignition) <+>”
• “Reprogram all keys including new ones? <+> Yes, <-> No”, PressontheSpeed+/Menu
Up button to continue.
• Iftheengine’snotrunning,thefollowingmessagewillbedisplayed:“Start Engine”
• Followedby“Turn Key to Pos. 1”, this will turn OFF the engine and the vehicle will remain in
accessory mode.
• TheLEDontheIIDToolwillashoncetoindicatekeynumberoneisbeingprogrammed.Itwill
turn solid to indicate completion.
• Removetherstkey.TheLEDwillashtoindicateitiswaitingforthesecondkey.
• Insertthesecondkeyandturnittoposition1.
• TheLEDonthetoolwillashtwicetoindicatekeynumbertwoisbeingprogrammed.Itwillturn
solid to indicate completion.
• Repeatuntilallkeysareprogrammed.
• Whenthelastkeyisprogrammed(LEDON),turnthekeytopositionII.
• Ifsuccessful,themessage“Operation succeed <+>” will be displayed. Key programming is
now complete.
Note : II Once the key is in position I, the IIDTool LED is used instead of the dashboard to indicate
status or completion stage
App : Simply follow instructions on screen.