Gap Diagnostic IIDTool - Bluetooth ECU (Other Languages, L322-2005, L322-06, L319-04)

174 175
IIDTool
GAP Diagnostic 2019-07-15 All Rights Reserved
User Manual : Version 33, Firmware V3.0
Bluetooth ECU (other languages, L322-2005, L322-06, L319-04)
User can choose between French, Spanish, German, Italian and English US voice languages.
Note: This update will only work on units with pairing code 2121. The dealer tted kits (pairing code
0000) cannot be updated.
Use
IIDTool Pro: all versions are embedded in the IIDTool Pro rmware.Usageofamobiledeviceisrequi-
red.
Regular IIDTool, all versions and IIDTool BT: Available upon request only.
Steps:
L322-2005 and L322-06
• SelecttheBluetoothre-ashandfollowtheinstructionsonscreen.
• TheprocessisdonewiththekeytotheAccessoryposition(I).Makesurethattheheadlightsare
turnedo󰀨andthatanyunnecessarylightsoraccessoryareturnedo󰀨also.
• Uponcompletion,turnthekeytotheONposition(II)andfollowtheinstructionsonscreen.
L319-04
• SelecttheBluetoothre-ashandfollowtheinstructionsonscreen.
• TheprocessisstartedwiththekeytoIgnition,positionII.Oncere-ashinghasbegun(indicated
on the Navigation screen), the key can be removed. It can also be left in position II in which
case the user should keep an eye on the vehicle and wait until completion (the instrument pack
will wake up). Failure to turn the key to the OFF position after the procedure is completed (or if
a failure occurred) will lead to a battery drain if not connected to a power supply.
• Uponcompletion,turnthekeytotheONposition(II)andfollowtheinstructionsonscreen.